Dont forget to use adequate lengths of rope, or safety cord for this project. You can use PVC pipe here as an insulator. Cut 3 or 4 pieces of 1 1⁄2 inch (3.8 cm) PVC pipe about 6 or 7 inches (15.2 or 17.8 cm) long. Drill 1⁄2 inch (1.3 cm) holes using a good drill bit, and never drill close to the end of the pipe. Realizationof the Dipole. He must remain you only one tube of diameter Round 8mm (0.31 inch) and two of 6mm (0.23 inch) of diameter. Insert on a depth of 6cm (2.36 inch), one of 6 mm (0.23 inch) round in the tube of 8mm (0.31 inch). Fix the with the help of a necklace. Alldimensions are given in mm on the first figure. The antenna is a Yagi type antenna, so it is composed of one reflector, visible on the bottom part of the figure. The reflector is split in two parts, but its overall length is 98 cm. The main dipole on the middle of the photo has also two (hopefully) identical parts. CellularYagi antennas are directional antennas that improve cellular signal in a single direction. This can be either reception or transmission of signal. Yagi antennas are used with cellular signal boosters to capture outside signal and bring them to the signal booster. Wilson 75 Ohm Wideband Yagi, F-Type Termination, 698-2700 MHz (314475 Telco20 Element Yagi Antenna - Next G, 4GX & 4G+: 700-890MHz . Key Features . Designed for Telstra & Optus Band 28 700MHz. Compatible with the Next G Network. If you're having serious problems with your Next-G broadband internet or mobile phone signal, the performance of this high quality fully welded aluminium antenna cannot be matched. DrAndre Fourie explains what the difference between a YAGI and LPDA (Log Periodic Dipole Array) antenna is. Why is an LPDA a better option for 2G, 3G, 4G an gOt0Qg.

how to build a yagi antenna for cell phones